DroneBeacon db300 blue UAS standard RemoteID module (MAVLink/DroneCAN))
This “Blue UAS” ready module is a RemoteID transmitter and can be used to have a standard RemoteID solution as required by the FAA for new drones. The db300 has both a MAVLink and two DroneCAN interfaces. It has a u.FL antenna connector and an antenna is included. The module can be integrated into your drone (product) that uses ArduPilot or PX4.
€ 69,00 ex. VAT
5 in stock (can be backordered)
This module is a RemoteID transmitter and can be used to have a standard RemoteID solution as required by the FAA for new drones. It is similar to the db201 module, it has both a MAVLink and two DroneCAN interfaces. It has a u.FL antenna connector and an antenna is included. The module can be integrated into your drone (product) that uses ArduPilot or PX4.
The db300 is “Blue UAS” ready. This means that the module fulfills the drone requirements set by
the U.S. Department of Defense/War for government use, ensuring they meet strict security and
operational standards. It is “Blue UAS” ready, because only DoD/DoW can approve components or
drones.
Specifications
RemoteID transmission protocols
Bluetooth dual-mode (legacy + Long Range)
FCC/CE certified radio module
*u-blox BMD-345
*Nordic nRF52840 radio
* External PA 24 dB
Transmit frequency:
* 2.4 GHz
Transmit power
* up to +32 dBm
Antenna: 3 dBi omni-directional antenna with IPEX connector (included).
Compliant with international regulation
*EU ASD-STAN DIN EN 4709-002
*USA ASTM Remote ID Standard ASTM F3411-22a-RID-B/ F3586-22
Connectivity:
*2x JST GH 4-pin CAN (DroneCAN) port
CAN 2.0 (1 Mbps) / CAN FD2 (up to 8 Mbps)
120 ohm termination: solder pad
*1x JST GH 6-pin TELEM (UART/MAVLink) port
115200 baud rate
Power: +5V supplied from TELEM or CAN port
LED lights: power (white) and status LED (red)
Fastening mechanism: 4x M2 screws (20 x 20 mm grid)
Size: 27.5 x 27.5 x 5 mm
Weight: 2.5 g (excluding antenna)
Operating temperature: -40°C to +125°C